San Juan Pools Showroom       Completed Enclosure     In the cold Canadian winter the San Juan corporate showroom gets ready for the installation of two Roll A Cover enclosures The pieces arrive at the site and are beginning to be unpacked. Each bay is laid out separately so that each one is installed in the correct order The pieces of this frees standing enclosures are no laid over the area where they will be installed Dave Pate, our head of engineering does some caulk work to ensure the enclosure maintains its integrity The bays are raised and the gussets are put into place And up they go The bays are now lifted and the bottom portions are Each bay is inspected to make sure that it correctly fastened The bays are then pushed into place The end walls are now prepared for installation They lift the end and line it up into place The top of the end wall is then lined up to the top of the enclosure and finally fastened on the bottom Now we will install the lean to onto the side of the showroom The bays are lifted and attached to the track The crane helps to get bays safely to the workers The roof is checked to make sure that all connections are correct and secure Elevation checks are made to ensure the the enclosure is level. The overlapping bays are now hoisted brought over to the enclosure.... ... and hoisted into place After a long day the enclosure is done. "Another satisfied customer says Dennis Martens, Vice President of Roll A Cover"